How to Install Daystar 2 in. Front Suspension Lift Kit on your Sierra

1. Read complete instructions before beginning installation and verify the bill of material.
2. Ensure you have correct tools before beginning.
3. Raise vehicle to remove wheels.
4. Remove the tires/wheels and support the vehicle.
5. Disconnect the sway bar link and move sway bar out of way.
6. Disconnect the ABS line from the upper control arm and knuckle.
7. Remove upper strut tower nuts.
8. Remove the lower strut bolts.
9. Remove upper ball joint nut and separate it by hitting the side of the knuckle with a hammer.
10. The strut will drop down.
11. Pull the strut down so you can remove the strut from the vehicle.
12. You will have to cut the stock strut bolts down so stud extender will screw down to the bottom of the stud. The length of stud after cut should be know longer than .750”
13. After you cut the studs, apply thread lock the stud and install the stud extender and lift spacer
14. Install the lower bolts first. The lower is under load so you will have to run up the bolts. The holes will be off but will line up when you install the bolts. Tighten to 37 ft-lbs.
15. Install upper part of strut using the lock nuts. Tighten to 20 ft-lbs. Do not us an in pack gun..
16. Reinstall the lower ball joint and sway bar and ABS lines.
17. Do wheel alignment after installing kit
18. RETORQUE ALL BOLTS AFTER 500 MILES.