How to Install AFE Mach Force XP 3in. Cat-Back Exhaust w/ Black Tips - Split Side Exit on your F-150

Step 1: (Read Instructions prior to installation) remove your stock exhaust up to the catalytic converter from the rear of your truck working
your way forward. Take caution not to damage the factory hardware and isolation mounts as they will be reused. It is recommend
ed to not fully tighten the clamps until the entire system has been installed.
Step 2: For faster installation spread the pieces of the exhaust alongside of your vehicle according to the diagram shown.

NOTE: Extension pipe may be needed for the following:

•CC/SB, SuperCrew / 5.5ft Bed, 145” Wheelbase No Extension pipe required
•EC/SB, SuperCab / 6.5ft Bed, 145” Wheelbase No Extension pipe required
•CC/LB, SuperCrew / 6.5ft Bed, 156.8” Wheelbase 15” Extension pipe (05-144045) required
•EC/LB SuperCab / 8ft Bed, 163.7” Wheelbase 22” Extension pipe (05-144046) required

Step 3: First insert and install the mid-pipe and extension tube (if necessary.) onto the muffler assembly.
Step 4: Slide the rear hanger of the muffler assy into the isolation mount first. Push all the way back until you have clearance to slide the
other front hanger of the muffler assy in place with the isolation mounts.
Step 5: Using the OE flange bolts and the nuts provided in the kit. Connect the flanges together. But do not fully tighten yet.
Step 6: Install the “Right” passenger side tailpipe first. Do not fully tighten.
Step 7: Next install the “Over axle”, do not fully tighten.